Drivers for the Adaptec Ultra SCSI 29320/39320 Host Bus Adapters KEYWORDS: openserver v5 osr5 adaptec adapter drivers bus pci ahs advanced hardware 5.2 supplement ftp down loadable ad320 scsi 29320 39320 aic 7901 7902 RELEASE: SCO OpenServer Enterprise System Release 5.0.6a, 5.0.7b SCO OpenServer Desktop System Release 5.0.6a, 5.0.7b SCO OpenServer Host System Release 5.0.6a, 5.0.7b HARDWARE: Adaptec 39320 PCI Controller Adaptec 39320A PCI Controller Adaptec 29320 PCI Controller Adaptec 29320LP PCI Controller Adaptec 29320ALP PCI Controller Adaptec 29320A PCI Controller AIC-7901A Controller AIC-7901B Controller AIC-7902A4 Controller AIC-7902B Controller PROBLEM: What drivers are available for the Adaptec Ultra320 SCSI Host Adapters? NOTE: This driver package is to be installed on: SCO OpenServer Release 5.0.6a, 5.0.7b NOTE: Refer to the ad320(HW) manual page (see ad320.HW.html in the download directory) for important information before installing this driver. NOTE: This driver is also shipped as part of OpenServer 5.0.7 Supplement CD 3. SOLUTION: This driver package is available at the following URL: ftp://ftp.sco.com/pub/openserver5/507/drivers/ad320_1.1/ Modification History -------------------- 2003-Aug-01 - Base release 2004-Jul-19 - Version 1.1 To install the driver, follow these sets of instructions: 1. Acquire the driver from the ftp address given above. - Download the btld image to a directory/file on your machine, for example, /tmp/ad320_btld.img. - Verify the downloaded image using sum: sum -r /tmp/ad320_btld.img This should return: 57342 2880 /tmp/ad320_btld.img - Format a floppy media using the format command. - Copy the downloaded image to the floppy: dd if=/tmp/ad320_btld.img of=/dev/fd0 bs=18k - Verify the copied floppy image using sum: sum -r /dev/fd0 This should return: 57342 2880 /dev/fd0 - Shutdown the host and install the Adaptec controller. 2a. Fresh Installation on Primary Drive - Insert a boot disk or Installation CD and boot up the system. - At the boot prompt type: defbootstr link=ad320 - Hit return and continue with normal installation. 2b. Secondary Drive Installation - Boot and Login normally. - Mount the floppy image: mount -r /dev/fd0 /mnt - Use the BTLD Install script to install the driver: /etc/btldinstall /mnt Once the kernel has been relinked reboot the host and verify that the driver is initializing the card. The boot time banner should look similar to the below: %adapter 0xec00-0xecff 11 - type=ad320 ha=0 slot=0 bus=0 id=7 fts=sto If you are installing this machine fresh with no additional operating systems or disks configured on the Adaptec Ultra320 adapter, it is recommended that you enable "Extended Int 13 Translation for DOS Drivers > 1 Gbyte" This is found in the Adaptec SCSI BIOS configuration Under "Advanced Configuration". If this is not a fresh install do not enable this option because it will make the contents of existing disks inaccessible. When the adapter is installed and the boot time banner is properly displayed, you may use the appropriate mkdev script to add a disk, tape, or cdrom to the Ultra SCSI Bus. Currently this version of the ad320 supports the use of up to two host bus adapters. Dual channel controllers count as two separate adapters. ---------------- Copyright (c) 2004 The SCO Group, Inc. All rights reserved.