Dear SCO Customer,

Support Level Supplement (SLS) ptf7639b, the UnixWare 7.0.1, 7.1.0, 7.1.1
vxvm-startup Supplement, addresses the problems listed below.


SLS ptf7639a addressed this issue:

1. On boot-up, volumes in Vxvm disk groups other than rootdg may not
   start. These volumes will show up in vxprint as DISABLED.


SLS ptf7639b additionally addresses this issue:

2.  This SLS will not install if the vxvm package is not present on
    the system.


Contents
--------

        /etc/init.d/vxvm-startup


Software Notes and Recommendations
----------------------------------

SLS ptf7639b should only be installed on:

        UnixWare 7 Release 7.0.1, 7.1.0, or 7.1.1

NOTE:  This supplement has been superseded by
the UnixWare 7.1.1 Maintenance Pack for UnixWare 7.1.1 platforms
only.  The UnixWare 7.1.1 Maintenance Pack is available from:

ftp://ftp.caldera.com/pub/unixware7/uw711pk


If your system is running any libraries or commands that are
contained in this SLS, then these programs will continue to run
with the old versions of these libraries or commands until the
the system is rebooted.

Note that when all necessary patches have been installed, it is
recommended that you reboot the system at the earliest opportunity.
This will ensure that no programs continue to run with the old
libraries or commands.


Installation Instructions
-------------------------

1. Download the ptf7639b.Z file to the /tmp directory on your machine.

2. As root, uncompress the file and add the SLS package to your system
   using these commands:

        $ su
        Password: <type your root password>
        # uncompress /tmp/ptf7639b.Z
        # pkgadd -d /tmp/ptf7639b
        # rm /tmp/ptf7639b

Alternatively, this SLS package may be installed in quiet mode,
that is, without displaying the release notes and asking for
installation confirmation.  To do this, use these commands:

        $ su
        Password: <type your root password>
        # uncompress /tmp/ptf7639b.Z
        # pkgadd -qd /tmp/ptf7639b all
        # rm /tmp/ptf7639b

3. There is no need to reboot the system after installing this package.

The release notes displayed prior to installation can be found in:

        /var/sadm/pkg/ptf7639/install/ptf7639.txt


Removal Instructions
--------------------

1. As root, remove the SLS package using these commands:

        $ su
        Password: <type your root password>
        # pkgrm ptf7639

2. There is no need to reboot the system after removing this package.


If you have questions regarding this SLS, or the product on which
it is installed, please contact your software supplier.